Internal Gear
| Module (mn) | |
|---|---|
| Driven Spline Gear (Z1) | |
| Driving Pinion Gear (Z2) | |
| ° α 20° N Pressure Angle | |
| Driving Pinion (Z2) Cycle |
| Helical Angle (β) | |
|---|---|
| Degree° |
|
| Minute' | |
| Second'' |
|
| Total Angle° | |
| Cosine Value |
| Driven Spline Gear (Z1) | |
|---|---|
| (Spline İnner Dia.) Outside Dia. (Øda1) | |
| Pitch Diameter (Ødo1) | |
| Minor Diameter (Ødf1) | |
| Base Diameter (Ødg1) | |
| Thread Depth (H) |
| Driving Pinion Gear Z2 | |
|---|---|
| (Spline İnner Dia.) Outside Dia. (Øda1) | |
| Pitch Diameter (Ødo1) | |
| Minor Diameter (Ødf1) | |
| Base Diameter (Ødg1) | |
| Center Distance (E) |
| Driven Z1' Transmission/Turnover Rate Calculation | |||
|---|---|---|---|
| Transmission Rate | |||
| Z1' Cycle | |||
| Z1' The Path Per Cycle (mm) | |||
| Z1'The Path Per Minutes (mm) |
Our company is not responsible for mistakes caused by the programs you use on our site. It is recommended to check the calculations. If you detect a mistake in the calculations, we kindly ask to you report it to our company.
The programs you have used have been registered with number 2021/4615 and protected by the relevant ministry, based on the software and program copyright law no 5846
Technical Teacher
Serdar Sağlam
The programs you have used have been registered with number 2021/4615 and protected by the relevant ministry, based on the software and program copyright law no 5846
It is a crime to copy, move to another place or open to use all or part of our programs and images. our company reserves the right to lawsuit.
Prepared byTechnical Teacher
Serdar Sağlam