Module (mn)
Driving N. Of Teeth (Z1)
N. of Teeth (Z2)
*Pitch Angle(ε)° Usually 90°
Driving (Z1) Gear Cycle
Helical Angle (β)
Degree°
Minute'
Second''
Total Angle°
Driving Gear Z1
~Outside Diameter (Øda1)
Pitch Diameter (Ødo1
Minor Diameter (Ødf1)
~Tooth Thickness (B1)
Pitch Angle(δ1)
Outside Angle (α1)
Rear Back Angle (θ1)
Cone Main Straight Length (Ra1)
Distance Between Center and Pitch Dia. (F1)
~Pitch Dia.- Distance Betw. Belly Protrusion (G1)
Virtual Tooth Number (Zi1)
Driving Pinion Gear Z2
~Major Diameter (Øda1)
Pitch Diameter (Ødo1
Minor Diameter (Ødf1)
~Tooth Thickness (B1)
Pitch Angle(δ1)
Outside Angle (α1)
Rear Back Angle (θ1)
Cone Main Straight Length (Ra1)
Distance Between Center and Pitch Dia. (F1)
~Pitch Dia.- Distance Betw. Belly Protrusion (G1)
Virtual Tooth Number (Zi1)
Common Values
~Biggest Tooth Depth (h)
Inner Module (mi)
Calculation of the Transmission/Cycle Ratio of the Driven Gear
Transmission Rate
Z2' Cycle (dev/dk)
Z2' The Path Per Cycle (mm)
Z2's The Path per Minutes (mm)
Konik Dişli Hesabı
Our company is not responsible for mistakes caused by the programs you use on our site. It is recommended to check the calculations. If you detect a mistake in the calculations, we kindly ask to you report it to our company.
The programs you have used have been registered with number 2021/4615 and protected by the relevant ministry, based on the software and program copyright law no 5846

It is a crime to copy, move to another place or open to use all or part of our programs and images. our company reserves the right to lawsuit.

Prepared by
Technical Teacher
Serdar Sağlam